At long last, a Slip Yoke Eliminator Kit is available for the NP242 transfer case used in XJ Cherokees and ZJ Grand Cherokees! Will Not work on a WJ Grand Cherokee. This Heavy Duty Slip Yoke Eliminator kit fits Jeep NP242J transfer case ONLY, which has a full-time four-wheel drive mode in addition to part-time Hi and Lo range. The transfer case can be identified by a round metal tag on the back of the transfer case right in the center. Be sure you properly identify which transfer case you have before ordering.

Get a Tom Woods Slip Yoke Eliminator Kit along with a Tom Woods CV Driveshaft for one low price! This is for the NP242 transfer case ONLY.

Rusty's will ship the SYE first, then once you receive it and install the SYE, Please measure for the driveshaft as noted below. With all the rear axle options, variations of lifts and suspension kits and long travel kits, there is no way to get the proper length driveshaft with us guessing even with our 45 plus years of experience.

This is the only proper way to get the best preforming and best fitting driveshaft for your vehicle. Once you call us with the proper driveshaft length, we try to ship the shaft the next business day if possible, if there is any delays we will call or e-mail you with the info. 

Please Note:
Any driveshaft over the length of 36 inches must be made of larger tubing and there is an up charge of $85.00.

MEASUREMENT INSTRUCTIONS :
Under the vehicle, take measurement from the yoke coming from your Transfer Case to the yoke on your Axle. Call us with measurement and we will send out your new driveshaft ASAP, which is usually 3 business days and allow 5 to 7 days for shipping depending on your location.

**Make sure to take the measurement with the vehicle weight on the suspension.

DRIVESHAFT MEASUREMENT GUIDE: